Why Is My Washing Machine Leaking?
Where the water appears tells you most of what you need to know.
A puddle at the front usually means the door seal or the detergent drawer. Water behind the machine usually means a hose or an inlet valve. Water underneath that only shows during a cycle usually means the pump or the tub seal.
Those are different repairs, and one of them is urgent.
Find where it's coming from first
Put a dry towel on the floor and run a short cycle. Watch rather than leaving the room.
Water at the front during filling points at the door seal or the detergent drawer.
Water at the back at any point points at the hoses or the inlet valve.
Water underneath during draining points at the drain pump or the drain hose connection.
Water underneath throughout, with a grinding or rumbling noise, is the one to take seriously. That usually means the tub seal has failed and water is getting into the bearings.
The four common causes
The door seal on a front loader. These wear out and split, often at the bottom where water sits. Pull the seal back and look in the fold. Coins, hairgrips and general debris collect there and tear the rubber.
The fill hoses. They're under mains pressure constantly, and they fail with age. Most should be replaced every five years, and the failure rate climbs sharply after that. A burst hose can put out hundreds of gallons an hour.
The water inlet valve. This controls water flowing into the machine. Hard water scales them up, and in this valley that happens faster than most places. They often show rust around the connection before they fail outright.
The drain pump. Lint, coins and debris get into it. Sometimes clearing the filter fixes it, sometimes the pump itself has cracked.
The one that usually isn't worth repairing
If the leak is from the tub seal and water has reached the bearings, you're looking at major components and the cost often exceeds what the machine is worth.
The signs are water underneath throughout the cycle, a loud grinding or rumbling noise, and the drum moving more than it should when you push it by hand.
We'd tell you straight if that's what we find.
What to do right now
Turn off the water supply to the machine. There are usually two taps behind it, for hot and cold.
If you can't reach them, don't run the machine until someone can look at it.
Mop up what's there and keep an eye on whether more appears with the machine switched off. Water appearing when nothing is running means a supply side problem, and that's the urgent kind.
Before you call
Check the fill hoses first. Pull the machine out, look for cracks, bulges or rust near the connections. If one looks damaged, that's your answer and it's an inexpensive fix.
Check the drain filter too, usually behind a small panel at the bottom front. Put a towel down, there will be water behind it.
And note when the water appears during the cycle. That single detail narrows it more than anything else you can tell us.
If you need it looked at
We repair washing machines across Salt Lake, Davis and Utah Counties, from Bountiful to Lehi.
Repair visits start with a $99 diagnostic, credited toward your repair if you go ahead. Tune-ups, cleanings and installations are quoted separately.

